Removing The Shelf Supports; Aqua Clean; Removing And Installing Door - Zanussi ZOB12401XU User Manual

To clean the door gasket, refer to the general
information about cleaning.

REMOVING THE SHELF SUPPORTS

To clean the oven, remove the shelf supports.
CAUTION! Be careful when you
remove the shelf supports.
1. Pull the front of the shelf support away from the
side wall.
2. Pull the rear end of the shelf support away from
the side wall and remove it.
1
Install the removed accessories in the opposite
sequence.

AQUA CLEAN

This cleaning procedure uses humidity to help
remove remaining fat and food particles from the
oven.
1. Put 300 ml of water into the cavity
embossment at the bottom of the oven.
2. Set the function:
3. Set the temperature to 90 °C.
4. Let the oven operate for 30 minutes.
5. Turn off the oven and let it cool down.
6. When the oven is cool, clean it with a soft
cloth.
WARNING! Make sure that the
oven is cool before you touch it.
There is a risk of burns.

REMOVING AND INSTALLING DOOR

The oven door has two glass panels. You can
remove the oven door and the internal glass panel
to clean it.
2
.
The oven door may close if you try to
remove the internal glass panel before
you remove the oven door.
CAUTION! Do not use the oven
without the internal glass panel.
1. Open the door fully and hold both hinges.
2. Lift and turn the levers on both hinges.
3. Close the oven door halfway to the first
opening position. Then pull forward and remove
the door from its seat.
15