Preparing A Unit For Installation - Texas Instruments TravelMate 5000 Series User Reference Manual

Caution: Texas Instruments does not warranty the use
of non-TI memory. TI will not be held responsible for
c
problems or degradation of performance incurred by
the use of any memory other than the TI memory
described in these instructions.

Preparing a Unit for Installation

To prepare a unit for installation, complete the following
steps:
Caution: Prevent component damage caused by
electrostatic discharge (
c
grounded-conductive floor mat or wrist strap to prevent
ESD
discharge static electricity from your hands, tools, and
containers by touching them to a grounded surface.
1.
2.
3.
4.
. Before touching the integrated circuit devices,
Turn off Quick Boot in the System Setup (refer to the
TM5000 Series User's Reference Guide for information
on Quick Boot).
Turn off the notebook, unplug the AC Adapter, and
remove the battery pack.
With the cover closed, turn the notebook upside down
on a padded surface.
Remove the two Phillips screws underneath the
memory expansion compartment located below the
floppy drive to remove the bezel.
RAM Expansion
). Use a high-impedance,
ESD
TravelMate Options 9-17