Maintenance - Jayco Mini Motorhome Owner's Manual

Warning: Low levels of CO have been linked to brain and vital organ
damage to unborn infants with no effect on the mother. Pregnant women
should leave the unit immediately if an alarm is sounded and not return until
the unit has been repaired and aired out thoroughly.
• If no one exhibits the symptoms associated with carbon monoxide:
1. Push reset button.
2. Turn off all sources of combustion including water heater, furnace, stove, oven,
RV and automobile.
3. Open windows and doors and move to a location that has fresh air.
4. Call a qualified technician and have the problem corrected before restarting
appliances and/or vehicles.

Maintenance

TESTING
WARNING: DO NOT attempt to test the detector by any other means than
using the "test" button. DO NOT attempt to produce carbon monoxide to test
the detector.
The CO detector should be tested weekly for proper operation:
1. Push the test button until the yellow LED lights and a short beep is heard for
approximately three seconds.
2. Release button.
The detector will test itself for proper operation. Upon completion of the self-test, the
alarm will sound and each of the LEDs will light for approximately ¾ second. The
detector will then resume normal operation.
BATTERY REPLACEMENT
Under normal operating conditions, the battery will last approximately one year. The
detector has a low battery monitor circuit which will cause the detector to make a
chirping sound then the red LED to flash every 30-40 seconds for a minimum of seven
(7) days indicating the battery is low. Replace the battery when this occurs. Use only the
following 9-volt batteries for the CO detector replacement:
Alkaline: Eveready 522, Duracell MN 1604, Gold Peak 1604A
Lithium: Ultralife U9VL
WARNING: Use only the batteries specified for replacement. Use of differ-
ent batteries may have a detrimental effect on the CO detector.
CLEANING
Use the following procedure to clean the CO detector:
1. Remove the detector from the mounting plat by rotating the detector in the direction
of the "OFF" arrow on the cover.
2. Clean the interior of the detector by using a vacuum cleaner hose and vacuuming
through the openings around the perimeter of the detector.
1 3