Table of Contents
Advertisement
12
Slide spacer front over front lip. Push spacer rear up,
then slide back over rear lip.
Installation
(DCWH/DCWN/DCWL Classic Chimney & DTWN Tall Traditional Wall Hoods)
1
1 -
1 3
( 4
/ 1
. 6
6 "
c m
1-1/2"x 3/4"
)
(3.8 cm) x (1.9 cm)
5/16"
wood strip
nut driver
Measure down 1-13/16 (4.6 cm) from desired height of
hood and secure 1-1/2" x 3/4" wood strip (not
included) to wall using screws provided.
3
5/16"
nut driver
CAUTION: Secure vent hood to wall using screws provided.
CAUTION: If not using a duct cover, using screws provided
Make sure mounting screws are secured into frame. Use
make sure top mounting screws are secured into soffit or
additional mounting screws and wall anchors, if necessary.
cabinet frame. Use additional mounting screws, if necessary.
44
13
Slide filter front over front lip. Push filter rear up, then
slide back over rear lip.
2
Slot for
wood strip
5/16"
nut driver
Use additional mounting screws to secure hood to
wood strip.
To install ventillation kit
refer to ventillation kit
installation instructions.
5
Slide spacer front over front lip. Push spacer rear up,
then slide back over rear lip.
Duct Cover Option
(DCWH/DCWN/DCWL Classic Chimney Wall Hoods)
1
Measure distance from ceiling to canopy.
45
4
Slide filter front over front lip. Push filter rear up, then
slide back over rear lip.
6
Slide filter front over front lip. Push filter rear up, then
slide back over rear lip.
2
Tape to avoid scratching.
Advertisement
Table of Contents
