Table of Contents
Advertisement
Installation
(DCH 12"H. Classic Chimney Wall Hoods w/Recirculating Kit)
1
Remove damper and discard with transition.
3
Attach with screws and lock washers provided.
5
Remove electrical box cover.
42
2
Turn recirculating unit upside down. Place vent hood
upside down on recirculating unit.
4
Attach with screws.
W A R N I N G
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING
• Use this unit only in the manner intended by the
manufacturer. If you have any questions, contact
the manufacturer.
• Before servicing or cleaning unit, switch power off
at service panel and lock service panel to prevent
power from being switched on accidentally. When
the service disconnecting means cannot be locked,
securely fasten a prominent warning device, such
as a tag, to the service panel.
6
1
Flip hood over. Insert 6" of electrical wiring through the
top of vent hood and secure using wiring restrain. Refer
to local codes.
8
BARE OR GREEN
GREEN
BLACK
WHITE
BLACK
WHITE
Connect black to black, white to white, and the
green/bare wire under the green screw.
NOTE: Housing wiring must be properly installed for
wiring to be correct when wiring unit.
10
Assemble brackets to mesh filters and insert charcoal
filters.
43
7
CAUTION: Secure vent hood. Make sure mounting
screws are secured into framing using additional
mounting screws and wall anchors, if necessary.
9
1
2
Replace electrical box cover. Make connection to
breaker box.
11
Slide filter front over front lip. Push filter rear up, then
slide back over rear lip.
Advertisement
Table of Contents
