Table of Contents
Advertisement
Set the cross bar (12) at desired distance from blade and
tighten screw. For ripping, the cross bar should be down
and against the straight edge of the workpiece as shown.
When circle cutting, adjust rip fence so that distance from
blade to hole in fence arm (13) is at the desired radius
and tighten screw. Place saw so that hole in fence arm is
over center of circle to be cut (drill hole for blade or cut
inward from edge of material to get blade into position).
When saw is properly positioned, drive a small nail
through hole in fence arm. Using rip fence as a pivot
arm, begin cutting circle. For circle cutting, the cross bar
should be up, as shown in figure H.
POCkET CUTTING (FIGURE I)
A pocket cut is an easy method of making an inside cut.
The saw can be inserted directly into a panel or board
without first drilling a lead or pilot hole. In pocket cutting,
measure the surface to be cut and mark clearly with a
pencil. Next tip the saw forward until the front end of the
shoe sits firmly on the work surface and the blade clears
the work through its full stroke. Switch the tool on and
allow it to attain maximum speed. Grip the saw firmly and
lower the back edge of tool slowly until the blade reaches
its complete depth. Hold the shoe flat against the wood
and begin cutting. Do not remove blade from cut while it is
still moving. Blade must come to a complete stop.
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never
let any liquid get inside the tool; never immerse any part of
the tool into a liquid.
REPLACEMENT PARTS
Use only identical replacement parts. For a parts list or to order parts, visit our service website
at www.portercable.com. You can also order parts from your nearest PORTER-CABLE Factory
Service Center or PORTER-CABLE Authorized Warranty Service Center. Or, you can call our
Customer Care Center at (888) 848-5175.
SERVICE AND REPAIRS
All quality tools will eventually require servicing and/or replacement of parts. For
information about PORTER-CABLE, its factory service centers or authorized warranty
service centers, visit our website at www.portercable.com or call our Customer Care
Center at (888) 848-5175. All repairs made by our service centers are fully guaranteed
against defective material and workmanship. We cannot guarantee repairs made or
attempted by others.
You can also write to us for information at PORTER-CABLE, 4825 Highway 45 North,
Jackson, Tennessee 38305, (888) 848-5175 - Attention: Product Service. Be sure to
include all of the information shown on the nameplate of your tool (model number, type,
serial number, etc.).
ACCESSORIES
WARNING:
have not been tested with this product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only PORTER-CABLE recommended
accessories should be used with this product.
A complete line of accessories is available from your PORTER-CABLE Factory Service
Center or a PORTER-CABLE Authorized Warranty Service Center. Please visit our
Web Site www.portercable.com for a catalog or for the name of your nearest supplier.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
Since accessories, other than those offered by PORTER-CABLE,
H
7
12
I
Hide quick links:
Advertisement
Table of Contents
