Coded Restore - Siemens SPCK420 User Manual

SPCK420/421/422 LCD-Keypad - User Manual
User programming via the keypad > Setting and unsetting the system > CODED RESTORE

CODED RESTORE

The feature provides the user with the ability to restore alert conditions that would normally only be available to the
installation engineer. To provide the user with this ability, it is necessary to protect this feature with a code.
To perform a coded restore on the system:
The security grade of the system must be set to Grade 3 or Unrestricted.
Ensure that the zone or fault that caused the alert condition has been physically restored to its normal operating
state.
Contact the installer before entering user programming and selecting the coded restore feature. The contact details
of the installer should be available from the drop down label beneath the keypad.
1. Press SELECT on the Coded Restore option.
A 6 digit reset code displays on the top line.
2. Provide 6 digit code to installer.
3. Receive newly generated code from installer.
4. Enter new code at the AUTH CODE prompt.
5. Press SELECT.
The message SYSTEM RESTORED displays on the top line of the display.
© Siemens Industry - 11-24-2009