Siemens SPCK420 User Manual page 23

SPCK420/421/422 LCD-Keypad - User Manual
User programming via the keypad > Setting and unsetting the system > UNSET
UNSET
To UNSET the system:
1. Enter a valid user code.
The keypad displays a prompt to unset the system.
2. Press SELECT.
The keypad display indicates that the system is unset on the bottom line of the display for approximately 5
seconds. After this time has elapsed, the bottom line is cleared.
3. If the alarm has been activated, enter the user code.
All bells and strobes are silenced.
The message PANEL DISARMED displays on the keypad for approximately 5 seconds.
The source of the alarm condition displays on the keypad and the Alert LED flashes.
The keypad continues to display the alert until the alert is restored.
© Siemens Industry - 11-24-2009