SOYO SY-K7VTA Pro Quick Start Manual page 20

SY-K7VTA PRO Quick Start Guide
The system turns on for some seconds then shutdown by itself.
1. check if the CPU fan is connected to the CPUFAN1 connector (For K7 and P4
M/B only)
2. the CPU might be overheating. Check the CPU FAN if it is defective or see if the
CPU fan is in contact with the CPU.
3. clear CMOS battery. (JP5 connector, see Quick start guide for more info on how to
clear the CMOS)
4. make sure the power supply you have on your system support the M/B
specification. Example. If you have a P4 M/B, you need to use a P4 power supply.
5. if you already checked the power supply specification, change the power supply it
might be defective.
6. remove the M/B from the case and test the system. The M/B might be shorted to
the case.
When I boot up my system, everything works fine, it sees my CPU and memory, detects
my hard drive, floppy drive and CD-ROM but locks up at "Verify DMI pool data... ".
Don't go any further. What should I do?
1. clear CMOS battery. (JP5 connector, see Quick start guide for more info on how to
clear the CMOS)
2. if still has the problem, unplug all other add-on cards except video card and floppy
drive see if it can boot from floppy. Then put peripherals in one by one to identify
which one cause the lockup
3. change the CPU
During Boot-up, my computer says CMOS memory Checksum error. What is the
problem?
1. clear CMOS memory
2. re-flash BIOS. Check on how to flash bios on the later part of this book
3. change the CMOS battery, the battery might be drained
4. the BIOS chip might be failing
5. This message will come up if the CMOS has been reset, try go to Bios setup and
load setup defaults, save and exit.
Stability issue
My system intermittently locks up, very unstable
1. check the CPU temp. it might be overheating. Check the CPU FAN if it is
defective or see if the CPU fan is in contact with the CPU.
2. check if there's heat paste on the CPU. (applicable only for K7 M/B)
20