SOYO SY-K7VTA Pro Quick Start Manual page 11

Connectors and Plug-ins
Standard IrDA (Infrared Device Header): SIRCON
Pin1 Pin2
+5V NC
USB3_4: USB3
Pin1 Pin3
+5V Data(-)
CPU Cooling Fan: CPUFAN1
Pin1 Pin2
GND +12V
Chassis Fan: CHAFAN
Pin1 Pin2
GND +12V
Connect the CD Line-in cord from the CD-ROM device to
the matching header CDIN1
STR LED
PWRBT
HDD LED
Speaker
HDD LED
Pin1 Pin2
LED GND
Connect your power switch to this header (momentary switch type).
To turn off the system, please press this switch and hold down for longer than 4
seconds.
Attach the ATX Power cable to this connector. (This motherboard requires an ATX power supply, an AT power
supply can NOT be used.)
When using the Power-On by PS/2 Keyboard function, please make sure the ATX power supply is able to
provide at least 720mA on the 5V Standby lead (5VSB) in order to meet the standard ATX specifications.
※Note: The STR LED is connected to the Voltage that feeds the DIMM sockets. Therefore
the following table applies:
STR LED
SY-K7VTA PRO Quick Start Guide
Pin3 Pin4 Pin5
IRRX GND IRTX
Pin5 Pin7
Data(+) GND
Pin3
SENSOR
Pin3
SENSOR
CD Line-in: CDIN1
Reset
Pin1
1 1
LED
Pin1
VCC
Power LED
PWRBT
Pin1 Pin2
PW-BT GND Power RST
ATX POWER On/Off : PWRBT
ATX Power Supply: ATX PW
Suspend to RAM
Blinking
11
Wake-On-LAN Header: J10
Pin1 Pin2
5VSB GND
USB3_4: USB4
Pin2 Pin4 Pin6
+5V Data(-) Data(+)
CPU Cooling Fan: CPUFAN2
Pin1 Pin2
GND +12V
Chip Cooling Fan: ChipFAN
Pin1 Pin2
GND +12V
Pin 1 Pin 2
L G
Power LED
Pin2
NC
Speaker
Pin2 Pin3
NC NC
RESET
Pin1 Pin2
GND LED Anode
Normal Operation
ON
Pin3
RING
Pin8 Pin10
GND GND
Pin3
NC
Pin3
NC
Pin 3 Pin 4
G R
Pin3
GND
Pin4
Speaker out
STR LED ※
Pin1 Pin2
GND
Power Off
OFF