Table of Contents
Advertisement
Navigate a Back Trail (backtrack, or reverse)
1. Press
MENU
2. Press ↓|↓ to enter the Saved Trail list, then use ↑ or ↓ to select the
desired Trail Name|
→
3. Press
to
D
4. Press ↓ to
begins showing reverse navigation information along the trail.
NOTE:
If you are already located at or near the end of your trail, the
arrival alarm will go off as soon as you hit
clear the alarm and proceed.
5. Now, begin moving and follow your unit.
6. When you reach your destination, be sure to cancel your navigation.
Press
|
MENU
MENU
←
sure, press
|
Transfer Custom Maps and GPS Data Files
Custom Maps:
Custom maps work only from the MMC card or SDC card. When a card
containing a Custom Map File is loaded into the unit, it automatically
loads the map into memory when the unit is turned on.
Instructions for copying Custom Map Files to an MMC are contained in
the instruction manual for your MMC card reader and MapCreate 6
software. For instructions on inserting a MMC into the Unit, see Sec. 2,
Installation/Accessories.
NOTE:
To load a Navionics
GPS Data files:
GPS Data Files contain waypoints, routes, trails and event marker
icons. Instructions for copying GPS Data Files between your computer
and a MMC are contained in the instruction manual for your MMC
card reader and MapCreate 6 software.
GPS data automatically recorded in the unit's internal memory must be
saved to the MMC as a GPS Data File in order to store it on your
personal computer. GPS Data Files stored on an MMC must be copied
from the card to the unit's internal memory before the unit can read
them. Here's how:
1. Insert the MMC into your unit. Press
|
|↓ to
MENU
M
.
ENT
|↓ to
T
ELETE
RAIL
|→ to
N
AVIGATE
↓
|
to
C
ANCEL
.
ENT
chart, see Sec. 8 for the entry Navionics Charts.
|
.
T
ENT
Y
RAILS
|
N
ENT
AVIGATE
|
|← to
R
ENT
EVERSE
|
N
AVIGATION
126
.
|
N
AVIGATE
. Just press
ENT
. The unit asks if you're
ENT
|
MENU
MENU
. The unit
ENT
to
EXIT
|↓ to
S
YSTEM
Hide quick links:
Advertisement
Table of Contents
