Adjusting Zero-Stop Set Screw - Shop fox W1835 Owner's Manual

Adjusting Zero-Stop Set
Screw
The zero-stop set screw (see Figure 27) keeps the saw
resting at exactly 90°. It can be adjusted using a 2.5mm
hex wrench.
To adjust the zero-stop set screw, do these steps:
1. Place the saw on a flat, level surface.
2. Align the outside edge of the saw with a carpenter's
square or a straight, level block.
3. Using the 2.5mm hex wrench, adjust the zero-stop
set screw until the outside edge of the saw is flush
against your square or block.
Model W1835 (For Machines Mfg. Since 12/12)
Figure 27. Location of zero-stop set screw.
-26-
Zero-Stop Set Screw