Kenmore 119.163018 Use & Care Manual page 14

install
Side Burner Frame to Firebox.
[] Unscrew the 2 Phillips Head bolts ¼" from the upper left and right corner holes in the left side of the
firebox as shown in Inset 1. The bolts extending out of the firebox sides are to attach the side
burner frame.
[] Slide the upper holes of the side burner frame over the heads of the 2 Phillips Head Bolts and drop
down.
[] Use 2 Phillips Head Bolts (M6x16mm) and 2 Lock Washers (M6) to attach the lower holes in the side
burner frame to the firebox as shown in Inset 2. Tighten the upper bolts after the 2 lower bolts are
tight.
Inset 1
Phillips Head Bolt M6x16mm
Qty: 2
©
Lock Washer M6
qty: 2
Inset 2
Install Side Burner Valve
[] Detach side burner ignition wire from the regulator hose if they are taped together.
[] Insert the side burner valve stem up through the hole in the Side Burner Control Panel. See
Inset 1.
[] Center the side burner valve in the side burner tube. See Inset 2.
[] Secure the side burner valve stem to the Side Burner Control Panel using 2 Phillips Head Bolts
(M4x8mm). See Inset 3.
Phillips Head Bolt M4x8mm
Qty: 2
nset 3
Inset 2
Inset 1
14