Table of Contents
Advertisement
1. Set up and initialize the parts relating to storing device.
1) HDD status : Display the hard disk status of a storing device.
(It displays maximum four hard disk device information that can be installed in the system.)
2) "HDD FORMAT" : Format currently selected hard disk.
When executing "HDD FORMAT", HDD format will be done when the system starts again.
(Causing by HDD formatting during system booting, the booting time takes about 6 minutes.)
(According to HDD capacity, the booting time may be varied.)
Note : Since disk format initializes a disk, all the data recorded until then will be deleted.
3) Overwriting : Set up a circulation storage use status. (On : Use, Off : Not use)
On : If a hard disk, storing devise, is full, it deletes automatically oldest recorded data so that it makes
to proceed recording image/audio (data) continually.
Off : When running a playback, if the hard disk(HDD) is full, the playback will be stopped automatically.
4) SMART alarm : Set up a SMART alarm use status. (On : Use, Off : Not use)
(SMART alarm : It is the self alarm detection function of the hard disk, it generates when hard disk has
an error in it).
* As shown in [Fig. 10], it displays "HDD information and capacity". If an installed (additionally
installed) HDD size will be expressed by OG, the system will have not recognized normally the HDD.
Format the HDD and then utilize it. Any recorded data will not be stored in a HDD not formatted.
2. Backup : It backups recorded data in an external type USB storing device.
1) Start date :Set up a start date to backup.
2) Start time : Set up a start time to backup.
3) End date : Set up an end date to backup.
4) End time : Set up an end time to backup.
5) "Backup" : Upon selecting a button, it starts backup.
Note : - If the available size of external type USB storing device is smaller than a data size to be
backup, the backup will not be done normally.
- While running a backup, a speed of the set may be come retarded.
- Transmission from the system to playback and network may make a backup speed retarded.
(In order to quicken a backup, stop a playback and then backup it.)
- Available backup devices support USB memory, USB external type hard disk.
(For an USB external type hard disk, it needs an additional power supply adaptor.)
- It does not support USB CD-RW and DVD-RW.
- If it cannot go on backup because it cannot recognize the correct size of a USB storing device,
format the storing device in window PC and then go on backup again.
<Figure. 11>
DIGITAL VIDEO RECORDER
29
DSR-815/1608
Advertisement
Table of Contents
