Inter-m DSR-815 Operation Manual page 27

1. Motion : Select the sensitivity and the area to detect motion.
1) Camera Select : Select a camera you desire.
[ DSR-1608 : (channel: 1~ 16) ; DSR-815 : (channel: 1 ~8) ]
2) Area : It sets up motion sensing area.
* NONE : Not use a motion detection.
* AREA : It selects a motion sensing area for special (part) area.
* ALL : It selects a motion sensing area for the whole area.
A
When you click on
(Set up a motion detection area for select/cancel with the mouse by dragging the selected area.)
[use of the front key and the remote control]
(1) Using the vertical and lateral (¢ ‚ ¢ " ) Key, displace an area.
(2) Using "ENTER" Key, set up an area Select/Cancel.
* When you select the key of outward direction of image area at the vertical and lateral edge, you can
select Row/Column.
(upper edge: ¡ª , lower edge: ¡ , left edge: ¢‚ , right edge : ¢" )
* Set up whole area : At [A] position, select ¢‚button and then ¡ªbutton.
At [B] position, select ¢"button and then ¡ªbutton.
At [C] position, select ¢‚button and then ¡ button.
At [D] position, select ¢"button and then ¡ button.
¡ Terminate a motion sensing area : Click on the right button of the mouse.
3) Sensitivity(%) : Select a sensitivity to detect a motion detection. [Insensitive 0~15 Sensitive]
4) Pre Record : Before a motion detection, Set up a PreRcord use status.(ON:Use, OFF: Not Use) [Default value : 3 Scond]
5) Post Record : After a motion detection, set up Record time(seconds).
6) Relay Out : Set up the relay output terminal.
7) Relay Out Duration: Set up a relay output retention time(seconds).
area, the motion area setting window will be activated.
<Figure. 8>
DIGITAL VIDEO RECORDER
27
DSR-815/1608