Storage & Backup - Inter-m DSR-815 Operation Manual

DIGITAL VIDEO RECORDER
2. Sensor : Set up sensor type, advance or post Record, alarm output, etc.
1) Sensor Select : Select a sensor channel you desire.
[ DSR-1608 : (channel: 1~ 16) ; DSR-815 : (channel: 1 ~8) ]
2) Sensor type : Set up a sensor kind.
(NO [NORMAL OPEN] and NC [NORMAL CLOSE] .)
3) Pre Record : Before a Sensor detection, Set up a PreRcord use status.(ON:Use, OFF: Not Use) [Default value : 3 Second]
4) Post Record : After a Sensor detection, set up Record time(seconds).
5) Relay Out : Set up the relay output terminal.
6) Relay Out Duration : Set up a relay output retention time(seconds).
¡ If you want to stop alarm motion while alarm motion is running, select "Alarm" Key on the front or set
up "Relay Out" to be None.
2-4. Storage & Backup : Set up a storing device and backup.
On the configuration screen as shown in <Fig. 1>, click on
[use of the front key and the remote control : Select "Menu" button, displace to corresponding menu with
the lateral (¢ ‚ ¢ " ) button, and then select "Enter" button.]
28
DSR-815/1608
<Figure. 9>
"Record".
<Figure. 10>