Removing And Replacing The Front Endo Housing - Motorola C330 Service Manual

Disassembly

Removing and Replacing the Front Endo Housing

24
1. Remove the rear housing cover, SIM, endo housing as described in the proce-
dures.
2. Using the Torx driver and a T-6 bit, remove the 6 screws shown in Figure 7A.
Set the screws aside for reuse.
3. Using the disassembly tool, release the latches along the two sides and on the
end of the phone as shown in Figure 7A
4. Carefully separate the rear endo housing from the front endo housing.
2
1
Figure 7. Removing the Front Endo Housing
5. To replace, align the front endo housing to the rear endo housing.
6. Carefully and gently press the front and rear endo housing together until the
two parts snap into position.
7. Insert and tighten the 6 screws in the sequence indicated by the arrows in
Figure 7A to a torque setting of 2.0 kgf. Do not overtighten.
8. Replace the SIM, and front and rear housing covers as described in the
procedures.
August 20, 2002
LATCH
5
REAR ENDO HOUSING
Product Family 0C35
6 3
LATCH
A
4
LATCH
FRONT ENDO HOUSING
B
020192o
6881040B65