Advertisement
Steering Wheel Control Module Installation, Radio Type and Button Configuration
1. Begin by installing the steering wheel control (SWC) device of your choice into the vehicle. Refer
to the installation instructions that came with the module of your choice and note any
limitations listed in the manufacturer's manual. E.G. "Will not operate Bluetooth buttons, etc." If
any button is not configurable it will not function with the StreamBlue. The StreamBlue remote
functions will not operate without one of the following 3 steering wheel control interfaces:
a. PAC® SWI-RC/X
™
b. Metra
ASWC-1
c. iDataLink© Maestro
2. Once the SWC of your choice is installed, follow the manufacturer's manual to program the unit
for:
a. Metra© ASWC-1: manually configure the device for CLARION 1
b. PAC® SWI-RC/X : configure for CLARION
c. iDataLink© Maestro : configure for Clarion with Bluetooth.
3. BUTTONS TO PROGRAM: Follow the manufacturer's directions to program the following
buttons once the unit is installed and the proper Clarion radio is selected: Volume up, Volume
down, Track up, Track down, Source and Mute.
SWC button
StreamBlue button equivalent
*VOLUME +
*VOLUME -
TRACK +
TRACK -
**SOURCE/MODE
MUTE
*Volume control is not supported when S/PDIF is used.
1. From the StreamBlue module harness (diagram on next page), connect the following:
a. Pin 10 (black) to chassis ground
b. Pin 1 (yellow) to a constant 12v source
c. Pin 2 (red) to a 12v accessory source
2. Plug the male 3.5mm jack from the steering wheel control interface (If steering
wheel controls are needed. If not, skip this step – See FIG 2 wiring diagram)
into the female 3.5mm jack on the StreamBlue harness.
3. Connect the audio output of your choice (RCA low level or S/PDIF) to the
amplifier/auxiliary input in the vehicle. This may require a pair of RCAs, RCA to 3.5mm
adapter or S/PDIF to TOSLINK adapter (not included).
:
Agreement
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
VOLUME +
VOLUME -
TRACK +
TRACK -
PAUSE/PLAY
MUTE
StreamBlue Installation
Functions may vary between
devices and OS'
**Holding the SOURCE/MODE button (3
sec) disconnects the last paired device
from the StreamBlue. A short tone will be
heard upon disconnect.
BHM
10/09/14
NTV-DOC190
rB7
3 |
P a g e
Advertisement
