Nav TV MERAV-NTG3 Operating Instructions

LOCATION & REMOVAL
Installation is made at the Command unit, the unit will need to be removed and dis-
connected from the car, ensure the vehicle is off and the key is removed.
Removing the COMMAND unit
ML example,
Open the ashtray door and remove two screws holding the ashtray, close the ash-
tray, unplug and remove.
Next pull the "climate control" trim below the Command unit (trim clips only) unplug
and remove.
Remove the two screws securing the silver Command unit locking tabs and slide the
locking tabs down to unlock the Command unit.

MERAV-NTG3 INTERFACE PROGRAMS

THERE ARE TWO PROGRAMS AVAILABLE FOR THE
NTG3 INTERFACE (loaded via USB)
*COMPATIBLE WITH GL / ML / R CLASS MERCEDES*
*COMPATIBLE WITH CLS / E / SL / SLK CLASS MERCEDES*
INTERFACE PROGRAMS CAN BE DOWNLOADED AT

INSTALLATION

1 Unplug the factory 40 way power connector from the radio.
2 Remove the Optical Fibre connector from the factory plug and insert it
into the Male side of the supplied 40 Way harness.
and White 12-way plugs if present)
3 Plug in the factory Male 40 way harness into the female of the
supplied 40 way harness, and connect the
4 If you are installing a Rear View Camera, plug the supplied Video
cable into the GREEN Fakra socket.
5 Plug the supplied A/V harness into the BLACK 18-pin socket.
Connect the A/V OUT, AUX VIDEO IN
REAR AUDIO IN as required.
4 5
Note;
The 3.5mm jack in the glove-box is shared for both AUX modes, AUX Audio and Au-
dio of AUX A/V. If you are installing an additional A/V source such as TV Tuner or
DVD Player etc, the Factory AUX Audio port will need to be used. You may use the
secondary AUX Audio labelled REAR in the Audio menu as a replacement.
&
www.nav.tv
(repeat for Black
MERAV-NTG3 interface.
, Secondary REAR OUT
Factory AUX 3.5 jack is used for Audio in
1
2

OPERATING INSTRUCTIONS

To activate Rear View Camera (For vehicles without a factory fitted camera);

With the Brake pedal depressed and the engine running, engage reverse gear.

To Activate AUX Audio;

Select "Video"
"Aux"
then select
To set Active Audio Source For the Rear;
Select the source name at the bottom-left of
the screen
DVD-Video
(for example "
"Active Audio Source For The Rear"
Select
Selected Audio source and DVD / AUX Video are now available for rear headphones
and rear screens (if installed)
To Activate "Video In Motion" for GL / ML / R Class
Double Click the " Voice off
Repeat to de-activate "
MERAV-
NOTE; Navigation does not track whilst "video in motion"
is active
To Activate "Video In Motion" for E / CLS / SL Class
Press " VOL UP" and "
Repeat to de-activate "
NOTE; Navigation does not track whilst "video in motion"
is active
Note: Prior to programming, turn off the vehicle and remove the key for 30 seconds,
Then turn the key to FULL IGNITION ON (Not Running). Be sure that the Cluster
display is in AUDIO MODE. During programming, the radio screen will display DIAG-
NOSIS, Then restart.

REAR VIEW CAMERA

ON
REAR OUT
and
ON

AUX VIDEO

ON

ALL FEATURES

ON
")
" button
Video In Motion"
SEEK UP " simultaneously
Video In Motion"

PROGRAMMING

GL / ML / R (Press and hold for 6 seconds)
OFF
GL / ML / R (Press and hold for 6 seconds)
OFF
GL / ML / R (Press and hold for 6 seconds)
OFF
E / CLS / SL (Press and hold for 30 seconds)
OFF