Programming The Rinsing Agent Dispensing System; Monitoring The Rinsing Agent Dosage; If You Are Using An External Dispensing System - Miele G 8072 Operating Instructions Manual

Venting and programming the dispensing system
Programming the rinsing agent
dispensing system
Whilst programming in the amount of
rinsing agent, P10 will show in the }
display, and the current rinsing
agent concentration will show in the
~ display. A value of 10 equates to
0.1 ml/l (the decimal point is not
displayed).
^ The dishwasher must be switched
off; if it is not, press [ to switch it off.
^ Press and hold X and Ä and at the
same time switch on the dishwasher
by pressing [ .
^ Press and hold control X, and at the
same time press Ä twice in
succession.
^ Press control §. The rinsing agent
concentration will be reduced to a
minimum of 0.1 ml/l, or 10 in display
~.
^ Press control °. The rinsing agent
concentration will be increased to a
maximum of 0.5 ml/l, or 50 in display
~.
^ Press control 4 to save the new
value.
The X control will light up red.
^ Press [ to switch the machine off.
28
Monitoring the rinsing agent
dosage
^ Check for any drying stains on
washed items, and adjust the dosage
if necessary.
– The dosage is correct if items dry
evenly without marks.
– You are using too much rinsing agent
if washed items are marked after
drying.
– You are using too little rinsing agent if
there are drops of water on items
after drying.
If you are using an external
dispensing system
You will require external dispensing
pumps to be fitted; please contact
Miele Professional for advice.