PowerBass L-1A Application Manual
  1. Manuals
  2. Brands
  3. PowerBass Manuals
  4. Speakers
  5. L-1A
  6. Application manual

PowerBass L-1A Application Manual

Aluminum/silk dome tweeter
Hide thumbs Also See for L-1A:
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

S-1S
L-1A
L-1A ALUMINUM DOME TWEETER
S-1S SILK DOME TWEETER
Application Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the L-1A and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for PowerBass L-1A

Summary of Contents for PowerBass L-1A

  • Page 1 S-1S L-1A L-1A ALUMINUM DOME TWEETER S-1S SILK DOME TWEETER Application Guide...
  • Page 2 ∆ Warning ∆ Continuous exposure to sound pressure levels in excess of 100 dB can cause permanent hearing loss. PowerBass Autosound Speakers are capable of producing sound pressure levels well over 170 dB. Please observe all local sound ordinances while listening to your PowerBass Autosound system.
  • Page 3 WIRING Your PowerBass Autosound Tweeters come complete with two (2) in-line 12dB/octave crossovers that have been computer optimized especially for use with your tweeters. These crossover net- works have color coded (red/black) speaker wiring permanently attached. After finding the best location for the crossovers, route the wiring to the radio (or source unit) and to the tweeter mount- ing location.

  • Page 4: Installation Procedures

    INSTALLATION PROCEDURES By mounting the tweeter separately from the woofer (or mid-range driver) the installer can choose the best location for sound quality and imaging. Three mounting types are possible allowing more versatility for the tweeter location. These are flush mount, surface mount, and angle mount. FLUSH MOUNTING (Type A) The best location for the tweeter is usually high up on the door and as far forward as possible without interference from the dashboard.
  • Page 5 POWERBASS COMPONENT TWEETERS These high quality tweeters come complete with several mounting housings for installation versatility. Typically tweeters should be mounted on axis and as close to ear level as possible. After you have chosen the housing to be used, gently press the tweeter in the proper mounting base. Once the tweeter base is mounted, push and “twist” the housing until it locks to the base.
  • Page 6 This warranty applies only to PowerBass products sold to consumers by Authorized PowerBass Deal- ers in the United States of America. Products purchased by consumers from a PowerBass dealer in another country are covered only by that country’s Distributor and not by PowerBass USA.
  • Page 7 This manual is the exclusive property of PowerBass USA, Inc. Any reproduction of this manual, or use other than its intentions is strictly prohibited without the express consent of PowerBass USA, Inc. Copyright 2008 PowerBass USA, Inc.
  • Page 8 PowerBass Autosound – A division of PowerBass USA, Inc. 13936 Mountain Avenue – Chino, CA 91710 Tel. (909) 993-5399 – Fax (909) 993-5393 www.powerbassusa.com...

This manual is also suitable for:

S-1s

Table of Contents