Panasonic EURO 4 Chassis Technical Manual page 36

3DQDVRQLF
13.2.1.Teletext Operation
To enable teletext processing by the microprocessor
IC1101 a CVBS signal is input via pin 68. Here the
signal is fed to the Teletext (TTX) slicer stage, where
the horizontal and vertical sync. information and
TTX data are extracted from the CVBS signal. To do
this the slicer has an analogue circuit for sync.
filtering and data slicing as well as an analogue PLL
used for system clock generation.
A third PLL is used to shift the system clock for data
sampling of the TTX signal.
Output from the slicer stage the sliced bit stream is
fed to the Acquisition stage where this bit stream is
converted into a byte stream and a framing code
check to identify the TTX signal takes place.
After framing code detection a status word is
generated which is used to identify the type of data
received and the signal quality of the TV channel.
The text data is then fed via the dual port interface to
the buffer, where under the control of the internal
CPU the data is stored in the display RAM until the
TTX data is required.
When the TTX data is requested the information is
read out of the Display RAM via the interface and
fed to the Display Generator.
The display generator then selects the pixel
information from the character ROM and translates
it into RGB values.
The character generator itself includes a character
and control decoder, a RAM interface, RGB and
Blanking signal generators.
To allow the character generator to carry out
processing of the TTX signal, generation of a pixel
clock is required.
This generation of the pixel clock is created
internally by the display timing stage which is fed a
horizontal and vertical sync signal input via pins 46
and 47.
The TTX data which has now been converted to
RGB values are then output from pins 37 (R), 38
(G), 39 (B) with the blanking signal being output via
pin 40. These signals are then fed to the VDP
and are discussed in the VDP Processor stage
section 17.
36
IC601