Step 4: Install The Speedstream 4100 Dsl Modem - PSC DSL Self Install Manual

Step 4: Install the Comtrend CT-5071T Modem
1. Connect the Data cable to the DSL port on the "Data" side of the
Data/Phone filter.
2. Connect the other end of the Data cable to the Line connection on the
back of the modem.
3. Connect the Ethernet cable to the LAN connection on the back of the
modem.
4. Connect the other end of the Ethernet cable to the Ethernet
connection on the back of your computer.
5. Connect the power supply to the Power connection on the back of the
modem.
6. Plug the power supply into an electric outlet.
7. Press the Power button on the back of the modem and verify that the
modem is powering up by the lights on the front. If you do not see any
lights on the front of the modem:
 Check that the power supply is plugged into a working electric
outlet, and into the power connection on the back of the
modem.
 Check that the power switch is pressed down.
8. Watch the ADSL link light on the front of the modem. It should start
flashing (training), and then become solid green. If the ADSL light
continues to flash after 2 minutes, or goes out:
PSC DSL Self-Install Guide
- 7 -