Storing Pauses In Memory; Using Redial; Storing A Redial Number Into Speed Dial; The Page Feature - VTech VT 2458 Manual

Operating Instructions

Storing Pauses in Memory

• To insert a pause in a phone number,
press PAUSE.The pause is approximately
4 seconds in length. For longer pauses,
press PAUSE two or more times. Each
additional press adds an additional 4
second pause.
• If your phone is connected to a PBX
you can store the PBX access number
and a pause before the phone number.
For example, to store 9-PAUSE-555-
1234 in memory location 8 do the
following:
• Press PROG.
• Press 8.
• Press 9.
• Press REDIAL/PAUSE.
• Dial 555-1234.
• Press PROG/MEM.

Using Redial

• To redial the last number you called,
press PHONE/FLASH then press
REDIAL/PAUSE.
automatically dial the number.
Storing a Redial Number into Speed
Dial
• To store the last number you dialed as
a Speed Dial number, press PROG/
MEM, a location number (0-9), REDIAL/
PAUSE, PROG/MEM.

The Page Feature

• From the Base Unit, press PAGE to
signal the person at the idle Handset.
• To end the page at the Base, press
PAGE again.
• To end the page at the Handset, press
OFF.
• If the Handset is in use (off-hook) when
PAGE is pressed on the Base Unit, the
Handset will emit one page alert. If the
Handset is not in use (on-hook), the
page alert will continue for approximately
60 seconds.
• The page alert will continue for
approximately 60 seconds.
The phone will
10