To Change Or Replace A Stored Number; Storing Pauses In Memory - VTech 918 ADX Instruction Manual

O P E R A T I N G
Press PHONE (on the Handset) or
SPKR (on the Base Unit) to get a dial tone
Press MEM and the Memory Location key
(0-9)
For example, to dial the number you as-
signed to key ' 8 ' , you would press
PHONE, MEM, 8 (on the Handset), or
SPKR, MEM, 8 (on the Base Unit).
900MHz
CORDLESS
PHONE INT.COM LOW BATT/MUTE
PWR
*
IN
USE
CHR
INT.COM
TO CHANGE OR REPLACE A STORED
NUMBER
22
You can change or replace a stored phone
number by storing a new number in its place.
See TO STORE A NUMBER INTO MEMORY.
TO ERASE STORED NUMBER
FROM MEMORY
The Handset must be OFF.
Press PRG/PRV on the Handset.
Press the Memory Location of the phone
number to be erased.
Press MEM on the handset to complete
programming.

STORING PAUSES IN MEMORY

918manual.pm6
I N S T R U C T I O N S
TO DIAL A NUMBER
FROM MEMORY
SPKR
VOL
22
To insert a pause while programming a
Memory Dial number, do the following on the
Handset:
Press PRG/PRV on the Handset
Press the Memory Location key where the
phone number will be stored (0-9)
Dial the number you want to store, press-
ing HOLD at the appropriate point (to insert a
2 second pause). The number can be up to
16 digits long. Each press of HOLD is treated
as stored digit.
For longer pauses, press HOLD two or
more times. Each press makes the pause 2
seconds longer and is treated as a stored
digit.
Press MEM on the Handset to complete
programming.
For example, if your phone is connected
to a PBX, you can store the PBX access
number and a pause before the phone num-
ber. To store 9-PAUSE-555-1234, in Memory
Location 8, you would:
Press PRG/PRV
Press 8
TO STORE PAUSES
IN MEMORY
900MHz
CORDLESS
PHONE INT.COM LOW BATT/MUTE
*
PWR
IN
USE
CHR
3/6/98, 3:21 PM
23
INT.COM SPKR
VOL