Worx WG108 Manual page 10

Table 1 minimum gauge for extension
cords
Volts
120V
240V
Ampere Rating
More than Not
more than
0-6
6-10
10-12
12-16
Figure 1 method of securing extension
cord
APPLIANCe CORD
CORD
SeT
10 10
j) Avoid unintentional starting. Don't carry
plugged-in appliance with finger on switch.
Be sure switch is off when plugging in.
k) don't abuse cord. Never carry appliance
by cord or yank it to disconnect from
receptacle. Keep cord from heat, oil, and
sharp edges.
l) don't grasp the exposed cutting
blades or cutting edges when picking
up or holding the appliance.
m)don't force appliance. It will do the job
better and with less risk of injury at the rate
for which it was designed.
n) don't overreach. Keep proper footing and
balance at all times.
o) Stay alert. Watch what you are doing. Use
common sense. Do not operate appliance
when you are tired.
p) disconnect appliance. Disconnect the
appliance from the power supply when not
in use, before servicing, when changing
accessories such as blades, and the like.
q) Store idle appliances indoors. When not
2-in-1 Grass Trimmer/Edger
Total length of cord in feet
25 50 100 150
50 100 200 300
AWG
18 16 16
18 16 14
16 16 14
Not
14 12
recommended
(A) tie cord as shown
(b) connect plug and
receptacle
in use, appliances should be stored indoors
in dry, and high or locked-up place, out of
reach of children.
r) maintain appliance with care. Keep
cutting edge sharp and clean for best
performance and to reduce the risk of
injury. Follow instructions for lubricating
and changing accessories. Inspect
appliance cord periodically, and if
damaged, have it repaired by an authorized
14
service facility. Inspect extension cords
12
periodically and replace if damaged. Keep
12
handles dry, clean, and free from oil and
grease.
s) Check damaged parts. Before further use
of the appliance, a guard or other part that
is damaged should be carefully checked
to determine that it will operate properly
and perform its intended function. Check
for alignment of moving parts, binding of
moving parts, breakage of parts, mounting,
and any other condition that may affect
its operation. A guard or other part that is
damaged should be properly repaired or
replaced by an authorized service center
unless indicated elsewhere in this manual.
3. EdGER-TRimmERS
a) keep guards in place and in working
order.
b) keep blades sharp.
c) keep hands and feet away from
cutting area.
4. Save these instructions. Refer to them
frequently and use them to instruct others
who may use this tool. If someone borrows
this tool, make sure they have these
instructions.
EN