8
Mounting and initial operation
8.
Mounting
01
8
Adjusting the table-top height
.01.01
Fig. 8 - 01
Loosen screws 1 and adjust the table-top height as desired.
Tighten screws 1 firmly.
This machine must only be mounted and operated by qualified specialist
personnel! All relevant safety regulations are to be observed!
The machine must be mounted where suitable electricity and compressed air
supplies are available (see specifications).
A horizontal and stable floor and adequate lighting must be present at the place
where the machine is mounted.
Due to reasons of packaging, the machine head and the stand are packaged
separately when destined for export. The mounting is described in the
following.
1
Mounting and initial operation
1
8 - 1