Mechanical Instructions - Philips 200WS8FS/00 Service Manual

Fig. 1
1. Lay down the monitor on the electrostatic cushion, then
wear your gloves, all tools (screwdriver, both with small and
big one) prepared.
Fig. 2
2. Put down the monitor softly and take out the base from
it.(note: care of the panel without scraped.)
3. Release the six screws and take out the plastic parts
between the rear cover and stand neck.
Mechnical instructions
Fig. 3
4. Release the two screws as below photo show, then take
out the metal parts between rear cover and stand neck, then
take off rear cover.
Fig. 6
5. Release the three screws on the left side of bezel, then
release the other three screws on the right of bezel.
200WS8 LCD
Fig. 4
Fig. 5
13