Table of Contents
Advertisement
Available languages
Available languages
_
FRONT INSTALLATION
Install the front grille(packed separately) onto the
cabinet as follows:
• Hook upper tabs of front grille into slots on the
cabinet top° (FIG, 19)
o Push front gritle's tips towards the cabinet in order
to snap side tabs into the cabinet, (FIG,, 19)
• Open the inlet grille., (FIG, 20)
• installthe screw (ITEM E) through the front grille.
(FIGo 20)
oCtese inlet grille. (FIG.,21)
Front lnstaflation
FIG, 19
Front Installation
_.t
Front installation
FIG. 21
_IF
AIR CONDITIONER IS BLOCKED BY
STORM WINDOW FRAME
, If storm windowpresents interference, fasten a 2'*
wide wood strip to the inner window sill across the full
width of the sill The wood strip should be thick
enough to raise the height of the window silt so that
the unit can be installedwithout interference from the
the storm window frame. See FfG 22
Top of wood strip should be approximately 3/4"
higher than the storm window frame to help
condensation to drain properly to the outside
• Install a second wood strip (approximately 6" long by
1V2"wide and same thicknessas first strip) in the
center of the outer sill flush against the back of the
inner sill Screw the L brackets into thisstrip
This will raise the L bracket as shown in F1G 22,
1 1/2" min
WOOD STRIP MOUNTED
(38ram)
ON TOP OF INNER S_LL
_ _
--_-
3/4"
CLEARANCE V
_L,
J"
]
4 _
_
WINDOW
INNER
]L BRACKET
I FRAME
J
J OUTER
l
I S LL
INSIDE
1
OUTSIDE
FIG, 22
REMOVAL
FROM WINDOW
• Turn off and unplug the air conditioner
. Remove the front grille, See HOW TO REMOVETHE
FRONT GRILLE Referto page 13
. Unscrew the sidescrews that you installed in Step 15
• Slide the air conditionerout ef thecabinet,
BE CAREFUL NOT TO DROP IT, Held onto it firmly the
whole way slidingit out Once removed,set it safety out
of the way
- Remove the L bracketfrom window frame and the sash
seal from betweenthe windows
• Unscrew the sidecurtainsfrom the window frame Fold
themback to thesides of the cabinet
=Remove screws attachingcabinet to inner sill Be careful
not te tot cabinet fall once screws are removed
• Removecabinet from windowopening,
• Place air conditionerinto cabinet Reinstallside screws
and Front Grille
• Place unit and all assemblyhardwarein air conditioner
shippingcarton, and store in clean, dry place
° Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people
are needed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques when moving unit
• When handling the air conditioner, be careful to
avoid cuts from sharp metal fins on front and
rear coils,,
• Make sure air conditioner does not fall during
removal.
-8-
Advertisement
Table of Contents
