Table of Contents
Advertisement
FEATURES
7
1
USING THE AIR CONDITIONER
_To
reduce the risk of fire, electric
shock, or injury to persons, read the important
SAFETY instructions
section before operating
this
appliance.
To begin
operating the air conditioner
after
installation,
follow
these steps:
1. Plug in the air conditioner.
(To prevent electrical
hazards, do not use an extension cord or an
adapter plug.)
2. Set the TEMP control to the coolest setting.
3. Set the MODE control at the highest COOL level.
4. Adjust the louvers for comfortable air flow.
5. Once the room has cooled, adjust the TEMP and
MODE control to the setting you find most
comfortable.
NOTE : If the air conditioner
is turned off, wait 3
minutes before restarting. This allows pressure
inside the compressor
to equalize. Failure to wait 3
minutes before restarting may cause inefficient
operation.
If you move the TEMP control to a warmer, then
immediately
back to a cooler setting, the unit will
shut off.
Wait 3 minutes before restarting.
Refer to the AIR CONDITIONER
FEATURES
section for other settings.(See
page 10)
FIG.
12
1. Cabinet
2. Horizontal
Air Direction Control Tab
3. Cool Air Discharge
4. Inlet Grille
5. Air Filter
6. Control Knobs
7. Upper Guide
8. Curtain
-9-
Advertisement
Table of Contents
