Table of Contents
Advertisement
_J
FRONT INSTALLATION
Install the front grille onto the cabinet as follows:
• Hook upper tabs of front grille into slots on the
cabinet top.(FIG.
19)
• Push front grille towards the cabinet in order to
snap side tabs into the cabinet.(FIG.
19)
• Open the filter door.(FIG.
20)
• Install the screw (ITEM E) through the front
grille.(Fig. 20)
• Close filter door.(Fig. 21)
Front Installation
FIG. 19
Front Installation
FIG. 20
Front Installation
FIG, 21
_"11F
AIR CONDITIONER
IS BLOCKED
BY
STORM WINDOW FRAME
• If storm window presents interference, fasten a 2"
wide wood strip to the inner window sill across the full
width of the sill. The wood strip should be thick
enough to raise the height of the window sill so that
the unit can be installed without interference from the
the storm window frame. See FIG. 22.
Top of wood strip should be approximately 3/4"
higher than the storm window frame to help
condensation
to drain properly to the outside.
• Install a second wood strip (approximately 6" long by
11/2 " wide and same thickness as first strip) in the
center of the outer sill flush against the back of the
inner sill. Screw the L brackets into this strip.
This will raise the L bracket as shown in FIG. 22.
1 1/2" rain.
WOOD STRIP MOUNTED
(38ram)
ON TOP OF INNER SILL
--='-I
_
314"
....
CLEA NCE
_-
STORM
WINDOW
_
FIG. 22
REMOVAL
FROM WINDOW
• Turn off and unplugthe air conditioner.
• Remove the front grille. See HOW TO REMOVE THE
FRONT GRILLE. Refer to page 12.
• Unscrewthe side screws that youinstalledin Step 15.
• Slide the air conditionerout of the cabinet.
BE CAREFUL NOT TO DROP IT. Holdonto it firmly the
whole way slidingit out. Once removed, set it safety out
of the way.
• Remove the L bracketfrom windowframe and the sash
seal from between the windows.
• Unscrewthe side curtains from the windowframe. Fold
them back to the sides of the cabinet.
• Remove screws attachingcabinet to innersill. Be careful
notto let cabinet fall once screws are removed.
• Remove cabinet from windowopening.
• Place air conditionerintocabinet.Reinstallside screws
and Front Grille.
• Place unit and all assemblyhardware in air conditioner
shipping carton, and store in clean, dry place.
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people
are needed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques when moving unit.
• When handling the air conditioner, be careful to
avoid cuts from sharp metal fins on front and
rear coils.
• Make sure air conditioner does not fall during
removal.
-8-
Advertisement
Table of Contents
