Sony VPL-S900U Service Manual page 18

Projecting
5
4, 6
STANDBY indicator
ON indicator
POWER
LAMP/COVER TEMP/FAN STANDBY SAVING ON
2
LIGHT + I / u
VOLUME
4 3
–
PATTERN INPUT
APA V MENU
B b
v
RESET ENTER
APA key
1
After all equipment is connected completely, plug the AC power cord
into the wall outlet.
The STANDBY indicator lights in red and the projector goes into the
standby mode.
2
Press the I / u key on the Remote Commander or on the control panel.
The ON indicator lights in green.
3
Turn on equipment connected to the projector. Press the INPUT key on
the Remote Commander or on the control panel to select the input
source.
INPUT A: Selects audio and video signals input from the INPUT A
INPUT B: Selects audio and video signals input from the INPUT B
VIDEO: Selects audio and video signals input from the AUDIO IN/
S VIDEO: Selects audio and video signals input from the AUDIO IN/
Note
The AUDIO IN jacks are used as audio outputs of both VIDEO and S
VIDEO.
Note on the VPL-S900E model
The optional IFB-X600E Interface Board is required for selecting
22
VIDEO.
(EN)
Rear remote control detector
1
Front remote control detector
COMMAND 2
I / u
OFF ON
MUTING
INPUT
AUDIO PICTURE
3
APA
APA key
MENU LASER
V
B b
ENTER R CLICK
v
RESET
VOLUME
+
–
connector.
connector.
VIDEO (VIDEO IN) jacks.
S VIDEO (VIDEO IN) jacks.
4
Press the PATTERN key on the control panel to display the H pattern,
and turn the focus ring to adjust the focus.
HHHH
HHHH
HHHH
HHHH
Press the PATTERN key again to clear the pattern.
5
Turn the zoom ring to adjust the size of the picture.
6
Turn the focus ring again to adjust the focus.
Note
Do not look into the lens when the projector lamp is on.
To
Adjust the volume
Cut off the sound
Cut off the picture
To get the clearest picture
You can get the suitable picture when a signal from the computer is input.
Press the APA key on the Remote Commander or on the control panel.
The picture is automatically adjusted to be projected clearest.
Notes
• Adjust the signal when the still picture is displayed on the screen.
• If you switch the input signal or re-connect a computer, press the APA
key again to get the suitable picture.
• "ADJUSTING" appears on the screen. Press the APA key again during
the adjustment to restore the original screen.
• "Complete!" appears on the screen when the picture is adjusted properly.
The picture may not be adjusted properly depending on the kinds of input
signals.
• Adjust DOT PHASE in the INPUT SETTING menu when you adjust the
picture manually.
For details on DOT PHASE, see page 28 (EN).
HHHH
HHHH
HHHH
HHHH
HHHH
HHHH
Press
the VOLUME +/– keys on the control
panel or on the Remoter Commander.
the AUDIO MUTING key on the
Remote Commander. To restore the
sound, press the AUDIO MUTING key
again or press the VOLUME + key.
the PICTURE MUTING key on the
Remote Commander. To restore the
picture, press the PICTURE MUTING
key again.
23
(EN)