Sony VPL-S900U Service Manual page 15

Location and Function of Controls
!º CONTROL S OUT jack (stereo minijack)
Connects to the CONTROL S IN jack on the projector
with the connecting cable (not supplied) when using
the Remote Commander as a wired one. In this case,
you do not need to install the batteries since the power
is supplied via the CONTROL S IN jack on the
projector.
!¡ ENTER key
!™ MENU key
!£ APA (Auto Pixel Alignment) key
!¢ MUTING keys
Cut off the picture and sound.
PICTURE: Cuts off the picture. Press again to
restore the picture.
AUDIO: Cuts off the sound from speakers and
AUDIO OUT jack. Press again or press the
VOLUME + key to restore the sound.
!∞ COMMAND ON/OFF switch
When this switch is set to OFF, no key on the Remote
Commander function. This saves the battery power.
!§ Transmission indicator
Lights up when you press a key on the Remote
Commander.
This indicator does not light up when you use the laser
pointer.
!¶ Infrared transmitter
!• Laser transmitter
!ª L CLICK key
Functions as a left button on a mouse. When connected
to a Macintosh computer, the L CLICK key functions
as a mouse button.
Battery installation
1
Push and slide to open the lid.
16
(EN)
2
Install the two size AA (R6) batteries (supplied)
with the correct polarity.
Be sure to install
the battery from
the ' side.
3
Replace the lid.
Notes on batteries
• Make sure that the battery orientation is correct when
inserting batteries.
• Do not mix an old battery with a new one, or
different types of batteries.
• If you will not use the Remote Commander for a long
time, remove the batteries to avoid damage from
battery leakage. If batteries have leaked, remove
them, wipe the battery compartment dry and replace
the batteries with new ones.
Notes on wireless Remote Commander
operation
• Make sure that there is nothing to obstruct the
infrared beam between the Remote Commander and
the remote control detector on the projector.
• The operation range is limited. The shorter the
distance between the Remote Commander and the
projector is, the wider the angle within which the
commander can control the projector.
• The remote control detectors on the projector do not
function when the connecting cable (not supplied) is
connected to the projector. When using the Remote
Commander as a wireless Remote Commander,
remove the connecting cable from both the Remote
Commander and the projector.
Note on wired Remote Commander operation
The laser pointer function does not work when you use
the Remote Commander as a wired one without
batteries.
Installing the Projector
This section describes the installation arrangements for installing the
projector on a table. For ceiling installation, consult with qualified Sony
personnel (see page 34 (EN)).
Horizontal center
of the screen
The distance between the lens and the screen varies
depending on the size of the screen. Use the following table
as a guide.
The following table shows the projection distance when the
SVGA signal (horizontal 800 × vertical 600 dots) is input.
• When XGA/SXGA signal is input, the projection distance
becomes shorter by 1.6%.
• When the Macintosh 16-inch mode or HDTV signal is input,
the projection distance becomes shorter by 4%.
Screen size (inches) 40 60 80 100
Minimum 1.6 (5.2) 2.4 (7.9) 3.2 (10.6) 4.1 (13.4) 4.9 (16.1) 6.2 (20.2) 7.4 (24.3) 8.2 (27.0) 10.3 (33.9) 12.4 (40.7)
Distance
Maximum 2.0 (6.6) 3.0 (10.0) 4.1 (13.4) 5.1 (16.8) 6.2 (20.3) 7.8 (25.4) 9.3 (30.5) 10.4 (34.0) 13.0 (42.6) 15.6 (51.1)
For detailed information on installation measurements, see page 33 (EN).
Adjust the vertical and horizontal positioning of the projector.
Vertical positioning (side view)
Screen
Adjust the height of the projector so that the center of
the lens is just above the bottom edge of the screen.
Horizontal positioning (top view)
Screen
Center of
the lens
57.5 mm
(2 3 /
8
inches)
Center of
the unit
Adjust the horizontal positioning of the projector so that the lens
is aligned with the horizontal center of the screen.
Note
Install the projector to be level.
Avoid followings which may cause malfunction.
• The projector topples over on its side.
• The projector titles more than 20 degrees.
20 degrees
20 degrees
20 degrees
Unit: m (feet)
120 150 180 200 250 300
17
(EN)