Sony VPL-S900U Service Manual page 17

Connecting
Connecting with a VCR, 15k RGB/Component Equipment
This section describes how to connect the projector with a VCR, external
active speakers and 15k RGB/component equipment.
For details on how to connect a computer, see page 18 (EN).
Also refer to the instruction manuals of equipment to be connected.
When making connections, be sure to:
• turn off all equipment before making any connections.
• use the proper cables for each connection.
• insert the plugs of the cables properly; plugs that are not fully inserted
often generate noise. When pulling out a cable, be sure to pull it out from
the plug, not the cable itself.
VCR
to S video
output
S-Video cable
(not supplied)
VIDEO IN
S VIDEO
AUDIO OUT
INPUT A
MOUSE
Active speakers
AUDIO OUT
Stereo audio
connecting cable
(not supplied)
15k RGB/component
equipment
to RGB/component output
Notes
• Select the RGB or component signal with INPUT-A or INPUT-B in the SET SETTING menu.
• Use the composite sync signal when you input the external sync signal from 15k RGB/component equipment.
• When connecting to INPUT B, make sure that the RGB IN/OUT select switch is set to IN.
20
(EN)
to audio/video
outputs
Audio/video cable
(VPL-S900U/M: supplied
VPL-S900E: supplied with the IFB-X600E Interface Board)
Set this switch to IN.
AUDIO IN
Rear
(MONO)
VIDEO L R
CONTROL S IN
PLUG IN POWER
IN
OUT
INPUT B
AUDIO MOUSE AUDIO
IN/OUT Note on the VPL-S900E model
The optional IFB-X600E Interface Board is required for
the VIDEO IN and AUDIO IN jacks.
VIDEO IN AUDIO IN
Rear
(MONO)
S VIDEO VIDEO L R
CONTROL S IN
PLUG IN POWER
IN
OUT
INPUT A INPUT B
MOUSE AUDIO MOUSE AUDIO
IN/OUT
Set this switch to IN.
SMF-402 Signal Cable (not supplied)
3X phono jack ˜ HD D-sub 15-pin (male)
or
SMF-400 Video Signal Cable (not supplied)
5X BNC ˜ HD D-sub 15-pin (male)
Using the RGB IN/OUT connector on INPUT B as a monitor output
connector
This section describes connections when using the RGB IN/OUT
connector on INPUT B as a monitor output connector.
When making connections, be sure to:
• turn off all equipment before making any connections.
• use the proper cables for each connection.
• insert the plugs of the cables properly; plugs that are not fully inserted
often generate noise. When pulling out a cable, be sure to pull it out from
the plug, not the cable itself.
• Make sure that the RGB IN/OUT select switch is set to OUT.
to INPUT A
Rear
SIC-S21 Mouse cable for serial port (supplied)
VIDEO IN AUDIO IN
(MONO)
S VIDEO VIDEO L R
Set this switch to OUT.
AUDIO OUT CONTROL S IN
PLUG IN POWER
IN
OUT
INPUT A INPUT B
SIC-S22 Mouse cable for PS/2 port (supplied)
MOUSE AUDIO MOUSE AUDIO
IN/OUT
Stereo audio connecting cable (not supplied)
SMF-401 HD D-sub 15-pin cable (supplied)
SMF-401 HD D-sub 15-pin
cable (not supplied)
to monitor
input
Monitor
Note
When the RGB IN/OUT select switch is set to OUT, the MOUSE
connector and AUDIO jack on INPUT B do not function.
to serial port
Computer
to mouse port
to audio out
to monitor out
21
(EN)