Front - Pioneer DDJ-SX Operation Manual

54. CH4 INPUTS: Connect an analog source on CH4 of the DDJ-SX mixer. You can
connect a MIC (jack input) or a CD-Player. The input is selectable via "INPUT
SELECT SWITCH" (64) on the front side.
55. CH2 INPUT: Connect an analog source on CH2 of DDJ-SX Mixer. You can connect
a turntable or a CD-Player. The input is selectable via "INPUT SELECT SWITCH"
(64) on the front side.
56. GND SCREW: Use it to screw your GND cable from turntables that provide it in
order to eliminate GND static noise.
57. CH1 INPUT: Connect an analog source on CH1 of DDJ-SX Mixer. You can connect
a turntable or a CD-Player. The input is selectable via "INPUT SELECT SWITCH"
(64) on the front side.
58. CH3 INPUTS: Connect an analog source on CH3 of the DDJ-SX mixer. You can
connect a MIC (XLR/Jack combo input) or a CD-Player. The input is selectable via
"INPUT SELECT SWITCH" (64) on the front side.
59. USB CONNECTOR: Use a standard USB cable to connect DDJ-SX with your
computer.
60. POWER SWITCH: Turns on/off the power on the device.
61. POWER INPUT: Connect the supplied power supply unit.
G. Front
62. HEADPHONES CONNECTOR: Use one of the two jacks to connect your
headphones.
63. HEADPHONES LEVEL: Adjusts the Headphones (CUE) Output Volume (Hardware
operation, not visible on the VirtualDJ GUI).
64. INPUT SELECT SWITCH: Selects the input of the corresponding channel of DDJ-
SX mixer. For VirtualDJ to operate the decks, you need to set these on "PC"
position.
65. CROSSFADER CURVE: Adjusts the curve of the crossfader.
66. TOUCH SENSOR LEVEL ADJUST: Use these two small knobs to adjust the
sensitivity of the touch sensors of DDJ-SX platters. Hardware operation.
VirtualDJ 8 – Pioneer DDJ-SX 17