Effects - Pioneer DDJ-SX Operation Manual

match. While those flash, the pitch slider of the DDJ-SZ will not control the pitch of
the deck until it meets the software value (soft take-over).
31. AUTOLOOP: Sets an Auto Loop. Hold SHIFT and press the same button to activate
a Saved Loop.
32. HALF/DOUBLE: Halves/Doubles the size of the Loop. Hold SHIFT and press the
1/2X or 2X buttons to move the triggered loop forward or backwards (step is relative
to the length of the loop).
33. IN/OUT: Use these buttons to set a Loop In and a Loop Out point (for manual
looping). Hold SHIFT and press the
34. PARAMETER: Offer various operations, depending on the PADs Mode (see PADS)
35. PAD MODE SELECT: Controls the PADs mode (see PADS)
36. PADS: Offer various operations, depending on the PADs Mode (see PADS)
C. EFFECTS
The Left FX section (FX1) controls by default the effects of the Left selected software deck
(1 or 3) and the Right FX section (FX2) controls by default the effects of the Right selected
software deck (2 or 4) respectively. Use the FX ASSIGN (45) buttons to assign a different
software deck to each one of the FX1 and FX2.
Each one of the FX unit offers 2 modes. The Single Effects mode offers one effect slot but
more parameters controls per effect. The Multi Effects mode offers 3 effect slots (to trigger
more than 1 effect at the same time – chained effects). The selection between those 2
modes is done by pressing the TAP while SHIFT is held.
VirtualDJ 8 – Pioneer DDJ-SX 10