Table of Contents
Advertisement
3.3.1. Serial port settings
MX16x16DVI-Slim and MX12x12DVI-Slim can be ordered with either RS-232 or
RS-422 communication port. The port settings are done in the factory. D-SUB
connector pin assignments can be found in chapter
The device uses standard RS-232 interface with the following settings:
3.3.2. Resetting the IP address
The unit‟s Ethernet port can be set to factory default IP configuration or to DHCP
mode with front panel buttons. To set the IP configuration perform the following:
Step 1. Ensure that there is no active connection on the Ethernet port. (unplugging
Step 2. Switch the router to TAKE mode if used previously in AUTOTAKE mode by
Step 3. Press and release Control Lock (Control Lock button lights in up red
Step 4. Press and keep pressed the Output Lock button (the current protocol
Step 5. Press and release the
Step 6. A light sequence will occur to confirm the command. (Save Preset, Load
Step 7. Reinsert the LAN cable to the Ethernet port if it was unplugged.
Step 8. Wait about 20 seconds before connecting the router via Ethernet.
Page 26 / 78
9600 Baud
8 data bit
1 stop bit
no parity
null modem cable
the LAN cable is the most secure)
pressing TAKE button for 4 seconds (light will go off).
continuously).
indication will light up).
a)
Load Preset button to set the factory default IP settings
IP address:
port number:
subnet mask:
gateway:
b)
Save Preset button to set DHCP enabled
IP address:
port number:
subnet mask:
gateway:
Preset and Take/Auto buttons will light up one after the other)
2.4.4
on page 18.
192.168.254.254
10001
255.255.0.0
0.0.0.0
Acquired with DHCP
unchanged
unchanged
unchanged
Section 3. Operation
Advertisement
Table of Contents
