3.3.2 Wire insertion/removal
When inserting/removing wires to/from the terminal block, push the driver as shown below and
insert or remove the wire.
3.3.3 Sensor connections & settings
3.3.3.1
Specification
The sensor specifications are as follows.
No. of inputs
Input types
Specification
Support Sensor
Connection method
Pulse width of usable
Electric
input
capacity
Output power
Sensor input terminal connection
Connect sensors to S1 ~ S16 as illustrated in the figure below. Please note that the figure
shows connecting sensors with dry contacts. Refer to the section on handling wiring for more
information about connecting or disconnecting sensor wires.
16 transistor input
N.C, N.O support
Dry contact sensor
Insert stripped wire end into terminal block
Minimum 500ms
Typical DC 12mA
41
Install Manual