Instructions for Use
11305_HV_Heritage_5650_MultiSteamer_Manual_FA.indd 14
(continued)
Filling the boiler with water
1. Place the cleaner on a flat level surface.
2. Make sure the cleaner is switched
off and disconnected from the mains
power supply.
3. Unscrew the filler cap by pressing down
and turning in an anti-clockwise direction
4. Fill the boiler with a maximum of 1.5 litres
of water by using the measuring jug and
funnel provided. Warm water may be used
which will reduce the heat-up time.
Do not use any detergent.
5. Refit the filler cap and fully tighten by
pressing down and turning in a clockwise
direction.
25/08/11 4:49 PM