Configuring The Operating System; Introduction; Calibrating The Touch Screen - Siemens Simatic MP 377 Operating Instructions Manual

Configuring the operating system

6.1

Introduction

For a description on how to configure the operating system, see the section "Configuring the
operating system" in the operating instructions "MP 377 (WinCC flexible)" as of edition
09/2007.
The following section includes the differences and amends the section of the same name in
the operating instructions listed above.
6.2

Calibrating the touch screen

Introduction
Depending on the mounting position and viewing angle, it is possible that parallax may occur
when operating the touch screen. To prevent any resulting operating errors, you may need to
calibrate the touch screen during the startup phase or while in runtime.
Nine calibration crosshairs are displayed during calibration of the touch screen. This setup
makes for extremely accurate calibration.
Requirement
These are the requirements:
You have opened the "OP Properties" dialog, "Touch" tab with the "OP" icon.
MP 377 15" Touch daylight readable (WinCC flexible)
Operating Instructions (Compact), 04/2009, A5E02532357-01
6
39