Desktop Mounting Footprint
Bolts, washers, screws, screwdriver or wrench needed when attaching the MX7 desktop cradle to a protected flat surface are
not supplied by Honeywell.
Periodically check the table mounting hardware and re-tighten if necessary. Table mounting hardware can be finger-tightened.
Note:
Do not over-tighten the table mounting hardware. If the cradle is cracked, it must be replaced before being placed into
service. Contact
2-6
1 Front
2 Table Mounting Hole Guides
3 Back
Technical Assistance
for help.
Not to Scale