Tuner Section
Tuner Section
(P -1000BR ONLY)
1
1. TUNING FREQUENCY DISPL Y
Displays the current frequency of the tuner.
2. TUNING LED
(P -1000BR ONLY)
This indicator lights when the digital tuner has locked onto a signal.
3. M/FM B ND SELECTOR ND MEMORY SWITCHES
This
M/FM Band Selector Switch is used to select the
Switch followed by one of the six
designated memory address.
4. DDRESS SELECT SWITCHES
These switches select between the six memory address banks used to store radio frequency presets. Each bank
can hold up to five individual presets – three FM (F1, F2, F3) and two M ( 1, 2), for a total of 30 presets.
5. UP ND DOWN SWITCHES
Pressing these switches will move the tuner to the next active frequency. Holding the switch down for more
than one-half second will activate " uto-Scan" mode, causing the tuner to scan, pausing for a few seconds at
each active frequency. Pressing the Up or Down switch again will de-activate " uto-Scan" mode.
6. TUNER LEVEL
(P -1000BR ONLY)
This knob controls the tuner output level. Rotating the knob fully counter-clockwise switches the tuner section off.
2
ddress Select switches will enter the currently selected frequency into the
(P -1000BR ONLY)
(P -1000BR ONLY)
PUBLIC DDRESS MPLIFIER/RECEIVER
3
4
(P -1000BR ONLY)
M or FM frequency band. Pressing the Memory
P -1000B/1000BR
5
6
5
Need help?
Do you have a question about the PA-1000B and is the answer not in the manual?