Cleaning Instructions; Figure 2 Grinder Assembly - Univex MG0012 Operator's Manual

CLEANING INSTRUCTIONS

1. Turn the grinder off and disconnect the power supply cord.
2. Disassemble the grinder in the reverse order of the assembly instructions:
Remove the storage container and feed pan.
Remove the ring, plate and knife.
WARNING: The knife is very sharp and can cut fingers.
Slide the worm assembly from the grinder housing.
Remove the grinder housing from the power unit.
3. Wash all the components including the drive coupling. Rinse, sanitize and air dry the components
4. Apply a small amount of food grade lubricant to the rear shaft on the worm.
GRINDER ASSEMBLY
FIGURE 2
 
 
 
 
  
  
 




Page 6