Advertisement
CLEANING INSTRUCTIONS
1. Turn the grinder off and disconnect the power supply cord.
2. Disassemble the grinder in the reverse order of the assembly instructions:
Remove the storage container and feed pan.
Remove the ring, plate and knife.
WARNING: The knife is very sharp and can cut fingers.
Slide the worm assembly from the grinder housing.
Unscrew the two knobs and remove the grinder housing from the power unit.
3. Wash all the components including the drive coupling. use the brush provided to clean areas that
are difficult to access. Rinse, sanitize and air dry the components
4. Apply a small amount of food grade lubricant to the bronze bushing located inside the grinder
housing before use.
RING
GRINDER ASSEMBLY
PLATE 1/8 (OPTIONAL)
PLATE 1/4 (OPTIONAL)
PLATE 3/8 (OPTIONAL)
PLATE 1/2 (OPTIONAL)
FIGURE 2
GUARD
LOCATING PIN
WORM
KNIFE
PLATE 3/16
Page 6
GRINDER HOUSING
LOCATING PIN
Advertisement
