Safety - Univex MG0012 Operator's Manual

SAFETY IS OUR TOP PRIORITY
READ AND MAKE SURE THAT YOU UNDERSTAND THE INSTRUCTIONS AND SAFETY
WARNINGS IN THIS BOOKLET BEFORE ATTEMPTING TO OPERATE THIS POWER UNIT.
IT IS A VIOLATION OF UNITED STATES DEPARTMENT OF LABOR REGULATIONS TO PERMIT
OPERATION OF THIS UNIT BY ANY PERSON UNDER THE AGE OF 18 YEARS.
FIRST TIME OPERATORS SHOULD BE PROPERLY TRAINED IN SAFETY PRECAUTIONS AND IN
THE PROPER USE AND SERVICING OF THIS EQUIPMENT AND ATTACHMENTS.
SWITCH THE POWER "OFF" BEFORE CONNECTING THE UNIT TO THE POWER SOURCE. MAKE
SURE THE SWITCH IS IN THE "OFF" POSITION, OR THE MACHINE WILL START WHEN THE
ELECTRICAL POWER IS RESTORED.
SWITCH THE POWER "OFF" AND DISCONNECT THE POWER SUPPLY CORD BEFORE MOUNT-
ING OR DISMOUNTING ANY ATTACHMENT OR FOR CLEANING OR SERVICING THE UNIT
FOR SAFETY, A SMALL PADLOCK (AVAILABLE AT ANY HARDWARE STORE) MAY BE PASSED
THROUGH THE SWITCH GUARD TO POSITIVELY LOCK THE SWITCH IN THE "OFF" POSITION
THE KNIFE IS SHARP AND CAN CUT FINGERS. USE CAUTION WHEN HANDLING THE KNIFE.
ALWAYS SECURELY MOUNT THE GRINDER, FULLY INSERT THE WORM ASSEMBLY INTO THE
DRIVE AND SNUG THE KNIFE, PLATE AND RING ONTO THE GRINDER BEFORE SWITCHING
THE POWER ON.
ALWAYS REMOVE THE GRINDER FROM THE POWER DRIVE UNIT BEFORE CLEANING.
NEVER WASH OR RINSE THE GRINDER ASSEMBLY WHILE MOUNTED TO THE DRIVE UNIT AS
THIS ILL INVITE ELECTRICAL SHOCK.
WIPE DOWN THE EXTERIOR OF THE DRIVE UNIT ONLY, NEVER HOSE DOWN OR IMMERSE
THE DRIVE UNIT IN WATER.
DO NOT ATTEMPT TO SERVICE THE DRIVE ASSEMBLY. PLEASE CONTACT UNIVEX
CORPORATION FOR THE NUMBER OF THE NEAREST AUTHORIZED SERVICE AGENT IN YOUR
AREA FOR ADJUSTMENTS OR REPAIR.
Page 3