Work Band - Baofeng UV-82 User Manual

24 None Freq Range
25 2 TX Power
TXP
26 10 / 11 RX/QT/DQT
R-DCS
R-CTS
27 12 / 13 TX/QT/DQT
T-DCS
T-CTS
28 5 W/N
W/N
29 1 Step
STEP
30 25 SFT_D
SFT-D
31 26 Offset
OFFSET
32 None Signal Code

Work Band

33 29 Wait Back Lt
WT-LED
34 30 RX Back Lt
RX-LED
35 31 TX Back Lt
TX-LED
36 35 Tail noise
STE Clear
37 36 Pass Repert
RP-STE Noise
38 37 Pass Repert
Noise (ms)
RPT-RL
39 38
Power On
PONMGS
No Options FYI Only
High/Low
OFF/D023N-D7541
OFF/60.0 -259.9
OFF/D023N-D7541
OFF/60.0 -259.9
WIDE/NARROR (W)
2.5/5/6.25/10/12.5/25khz Sets the space
Frequency
OFF/+/-
00.00 – 99.950
00.00 -69.990 (manual)
1 -15
OFF/Blue/Orange/Purple You get to choose
OFF/Blue/Orange/Purple You get to choose
OFF/Blue/Orange/Purple You get to choose
OFF/ON
OFF/100....1000
OFF/1..10 Manual
OFF/100....1000
OFF/1..10 Manual
Disp Full/MSG
FYI only.
Fixes the power at
desired levels.
Sets the RX tones to
open the receiver.
Sets the TX tones to
open the receiver on
the repeater.
Sets the bandwidth
between frequencies
scanned whether by
Up/Dn arrows or the
scan function (*).
Sets the direction of
any shift in TX vs RX
Sets the amount of
offset. In the US:
VHF=.600 UHF=5.00
Special application to
call certain radios
only
your own colors !
your own colors !
your own colors !
Eliminates noise at end
of transmission between
units of the same breed
using simplex.
Eliminates noise at end
of transmission between
repeater & transceiver.
Delays the tone by the
setting. See #37.
Full is a power-on
LCD test.
MSG allows for your
custom sign on.
Can be changed
using the
"Other" menu
in VIP version.
Good practice
to start on Low.
Usually left to
OFF unless a
noisy/busy area.
Unless your
area uses the
same tones set
to OFF
Most Ham use
is WIDE.
5khz is the
normal for US.
Repeater
dependent
Repeater
dependent
Not Ham
related.
See #5 above.
See #5 above.
See #5 above.
Set to OFF
when using
repeaters, so
leave it off.
Set to OFF
when using
repeaters.
Set to OFF
when using
repeaters.
Gives a brief
sense of
accomplishment
& checks LCD.