Programming Memories Baofeng Uv 82; Programming A Channel With Standard Offsets - Baofeng UV-82 User Manual

PROGRAMMING MEMORIES BAOFENG UV 82

Frequency Mode
These two modes have different functions and often confused.
Frequency Mode - Used for a temporary frequency assignment, such as a test
frequency or quick field programming.
Channel Mode - Used for selecting preprogrammed channels.
All programming MUST
Display only. From there you have the option of assigning the entered data to a
specific channel for later access in the
IMPORTANT: Programming done using the Lower display cannot be saved and
will be lost.

PROGRAMMING A CHANNEL WITH STANDARD OFFSETS

Programming a Repeater Channel with Standard Offsets
This example is for: 146.700 MHz 600kHz minus offset into channel 99 CTCSS
tone 123.0
1. Set radio to VFO Mode (Frequency Mode)
a.) UV5R/GT3 - Press VFO/MR button
b.) UV82 - Turn radio OFF, then Press/Hold MENU button during PowerON.
2. Select Display A (this is a must)
a.) UV5R/GT3 – Press [A/B] and select the Upper Display.
b.) UV82 - Press [EXIT A/B] and select the Upper Display.
3. Disable TDR (Dual Watch/Dual RX) which toggles between A and B.
Press [Menu] 7 [Menu]
Select OFF
Press [Menu] [Exit]
4. Delete Prior Data from the channel to be programmed.
Press [Menu] 2 8 [Menu]
Enter 9 9 (Memory Channel to clear)
Press [Menu] [Exit]
5. Enter the Repeater Offset.
Press [Menu] 2 6 [Menu]
Enter 0 0 6 0 0
Press [Menu] [Exit]
6. Enter the Transmit Frequency Shift.
Press [Menu] 2 5 [Menu]
Enter 2 for Minus shift.
Press [Menu] [Exit]
7. Set CTCSS or DCS codes for Transmit.( example = CTCSS TX tone 123.0 Hz )
Press [Menu] 1 3 [Menu]
vs. Channel Mode
be initially done in the
PROGRAMMING MEMORIES BAOFENG UV 82
Frequency Mode
Channel Mode if desired.
1
using the Upper