Hitachi RAS-H(V)RNME-AF Service Manual page 289

11 Servicing
Remove the fan motor connector from the PCN202 and
PCN203 at the electrical box.
• Cut off the cable tie that fixes the lead wire of the fan
motor.
• Remove the four (4) screws that fix the motor to the mo-
tor clamp.
Fix the motor wire with the cable tie or the cord clamp. If not,
it may cause the disconnection of the fan motor's lead wire.
In order to avoid cutting edges, mount the rubber bush at
the partition plate when inserting the motor wire through it.
If not, it may cause the disconnection to the fan motor's
lead wire.
No.
1 Partition plate
2 Rubber bush
3 Cord holder or cable tie
N O T E
• When assembling the motor, ensure the cables section directly downwards. Fix the protection tube edge end
downwards to ensure water from keeping inside it.
• Fix the motor wires onto the motor clamp with a cable tie to prevent them from collisioning the fun blades.
• Assembling the fan blade: Insert the skidding protection part of fan boss in accordance with the cutting part
of the motor shaft, and fix the screw after dismounting the screwed part of the shaft. (Tightening Torque of
20 N.m)
• When connecting the motor wire, check to ensure that the colors of the connectors on the PCN201 and PCN202
are matched with the wires.
• Fix the air outlet grille firmly to the shroud.
279
SMGB0070 rev. 1 - 08/2011
Part
1
3
Install DC motor to this position facing down the trap
2
11