Assembly - Power Wheels Kawasaki NINJA 73690 Owner's Manual & Assembly Instructions

F
WARNING
Children can be harmed by small parts,
sharp edges and sharp points in the
vehicle's unassembled state, or by electrical
items. Care should be taken in unpacking
and assembly of the vehicle. Children
should not handle parts, including the
battery, or help in assembly of the vehicle.
1
Right Fender
Pegs
Bottom View
• Position the vehicle body upside down.
Note: The mudflaps are marked "R" and "L" to designate
right and left.
• With the "R" marking facing up, align the two round
holes in the right mudflap with the pegs on the inside of
the right fender.
3
• Insert two #8 x / " screws through the round holes in the
4
right mudflap and into the right fender.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.

Assembly

Round Holes
Right
Mudflap
2
Oval Holes
• Align the two oval holes in the right mudflap with the
pegs on the inside of the right fender.
3
• Insert two #8 x / " screws through the oval holes in the
4
mudflap and into the right fender.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Repeat assembly steps 1 and 2 to assemble the left
mudflap ("L") to the left fender.
3
• Fit a .437 cap nut onto one end of the rear axle.
• Tap the other end of the rear axle with a hammer to
secure the cap nut on the end of the rear axle.
Hint: You may want to position the cap nut on a scrap
block of wood to protect the assembly surface.
9
Right
Mudflap
Bottom View
Rear Axle
.437
Cap Nut