Battery Installation - Power Wheels Kawasaki NINJA 73690 Owner's Manual & Assembly Instructions

H
IMPORTANT! Use only a Power Wheels
with built-in thermal fuse. Use of any other battery will
damage your vehicle. Make sure that you charge the battery
for at least 18 hours using the enclosed Power Wheels
12 volt charger before operating your vehicle for the first
time. Charge the battery for at least 14 hours after each
use of the vehicle. Never charge the battery longer than 30
hours. Failure to follow these instructions may damage your
battery and will void your warranty.
1
Vehicle
Body
• Press the tab under the back of the seat and lift to remove
the seat.
2
Slot
• Squeeze the battery clamp arms together to release the
arms from the slots in the vehicle body.
• Press the battery clamp arms in and over the lock
tabs and lift the battery clamp.

Battery Installation

® 12 volt battery
3
®
Seat
• Place the battery upright in the battery compartment.
• Plug the motor harness connector into the battery. Push
firmly to join.
Tab
4
Slot
• Lower the battery clamp over
the battery.
• Fit the battery clamp arms down into the slots in the
vehicle body.
• Press the battery clamp arms out over the lock tabs to
Battery Clamp
snap and secure the battery clamp arms in the slots.
Arms
• Re-assemble the vehicle seat.
17
Slot
Arm
Battery
Motor
Harness
Connector
Slot
Arm